65QVL-SPR Lengthening Sump Slurry Rubber Pump

65QVL-SPR  Lengthening Sump Slurry Rubber Pump

•      Product Introduction

65QVL-SPR  is single casing sump slurry pump.It is vertical, centrifugal slurry pump submerged  in water to work. The pump belongs to extended SPR sump slurry pump,which can be applied to the condition of deep liquid level.All parts of the pump immersed in liquid are lined with rubber outer liner. They are suited to transport non-edge angle corrosive slurry. The Pump needn't shaft sealing or sealing water.It is able to operate normally under condition of insufficient suction volume.  

         65QVL-SPR sump slurry pump is widely applied to sewage treatment ,metallurgy, mining, coal, power plant, building materials industries and so on.

1   Shaft                      

2  Cylindrical roller bearing           

3   Bearing housing                      

4   Bearing spacer    

5   Double row center conical roller bearing

6   Mounting plate                        

7    Column support              

8    Strainer                   

9   Rear liner                              

10   Impeller                                

11   Pump casing

12    Lower strainer      

13   Discharge pipe                       

14   Flushing pipe                         

15   Coupling part      

16   Middle supporting part      

 •     Product Feature

1. Vertical, centrifugal and Single-casing structure.
2. The Impeller is double suction half-open structure, adopts wear-resistant alloy or rubber.
3. The bearing assembly is cylinder type structure, the bearing could be lubricated by grease.
4. The clearance between the impeller and the cover plate could be adjusted to ensure the   pump to operate at high efficiency point.
5. Needn`t shaft sealing or sealing water.
6. Direct drive, V-belt drive could be selected to connect with the drive.
7. The lengthened series of long shaft sump slurry pump can be applied to the condition of deep liquid level. This kind of pump has added guide bearing structure on the basis of standard pump, which makes the operation more stable and applies more widely. However, the bearing should be equipped with flush water.

 •      Range of Performance

Capacity     22.5~105m3/h

Head          5.5~30.5m

Discharge diameter: 65mm

 •      Drive Type

 •      Type Of Pump Inlet Construction

 •      Outline Drawing